How you can Replace The Basket Drive and Brake Tube Set up Inside A Kenmore Direct Drive Washer

Stick to the directions below to get rid of the basket drive & brake set up:

Disconnect the washer in the wall plugTurn water taps off and take away the fill hoses the in the water valve (place a towel on the ground underneath the fill hoses to trap water dripping in the hoses)Make certain that there's no water around the washer and take away the drain hose (place a towel on the ground underneath the drain hose to trap water left around the hose and also the pump)Open the controls panelTake away the cabinetTake away the agitatorTake away the tub coverTo get rid of the bathtub cover, press lower around the cover and disconnect the holding tabsNow you will have to make use of a spanner nut wrench to get rid of the spanner nutAfter getting rid of the spanner nut, you will have to take away the spin drumTo get rid of the spin drum you will need to rock it laterally until it breaks loose and you can remove itTake away the basket drive block by tapping up having a hammer until it arrivesNow you will have to lay lower the washer on the ground. Make certain you place or perhaps a rug or something like that else on the ground to safeguard the washerDisconnect the hoses in the pumpDisconnect the wire harness in the motor and make certain they aren't connected to the gearcase before getting rid of the gearcaseUnscrew the 3 gearcase holding screws or bolts and take away the gearcaseNext you will have to turn the brake cam driver counterclockwise to compress the brake so that as you switch it, start like unscrewing it (it's not screwed in, however the unscrewing motion appears to assist obtaining the basket drive & brake tube out

Stick to the directions below to set up the basket drive & brake set up:

Begin by setting up the basket drive & brake tubeGrab the brake cam and switch it counterclockwise while pushing the basket drive & brake set up completely in/li>Make certain to achieve the sprint at approximately 12 o'clock and brake cam at approximately 6 o'clockInstall the apparatus situation and tighten the 3 holding screws or boltsConnect the wire harness towards the motor and secure it towards the gearcaseInstall the hoses towards the pumpSet the basket drive block around the basket drive & brake tubeSet the spin drum in position and screw the spanner nut while using spanner nut wrench. Make certain is tightInstall the bathtub cover and make certain the tabs secure placeInstall the agitatorConnect the two fill hoses and open water tapsConnect the washer towards the wall plug and give it a try

If you wish to see my free videos regarding how to do that repair click the link within my authors resource box.